SmallRig Dual NP-F Battery Plate Kit 15mm LWS Rods, Power Supp | Shop The World
From USA
NewSMALLRIG
SmallRig Dual NP-F Battery Plate Kit for 15mm LWS Rods, Power Supply for D-Tap, DC, USB-C Ports, Adapter Mount Plate for NP-F550 / 570/750 / 770/950 / 970 Batteries, Supports UPS - 5537
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
Safe and trusted checkout with major payment methods
4.5 (379 Trustpilot)
4.5/5 · 379 reviewsTrustpilot
•【For Dual NP-F Batteries】This adapter plate supports one or two NP-F batteries to power your mirrorless cameras, monitors, or other devices. It suitable for NP-F550 / 570 / 750 / 770 / 950 / 970 batteries or more. When two batteries are installed, it allows you to replace one battery without shutting down connected devices, ensuring an uninterrupted power supply (UPS).
•【Multiple Power Supply】The power supply base is equipped with built-in D-Tap, DC (5521), and USB-C ports, enabling simultaneous charging for multiple devices. The ports are scientifically arranged to avoid interfering with camera operation or the use of top handle. The USB-C port also supports a maximum input of 36W, allowing the base to function as a charging dock.
•【Intelligent Power Management】The built-in smart chip manages power intelligently. In discharge mode, it prioritizes the lower-charge battery, switching to dual-battery output when needed for easier swapping and higher-power support. In charge mode, it prioritizes the higher-charge battery and then switches to dual-battery when low-charging to enhance efficiency.
•【Independent Power Control】The built-in power switch allows you to check the battery level and turn on output with a single press, or turn off the output by holding it for 2 seconds. This user-friendly design eliminates the need to unplug cables after shooting and helps conserve battery power.
•【3 Mounting Options】The battery plate can be mounted using a V-mount plate adapter or via the 1/4"-20 threaded hole at the bottom. It can also used by included 15mm rod clamp (60mm on-center spacing). Once mounted, it can be powered by installing one or two NP-F series batteries to supply your devices.
From USA
