serplex 24w electric foam cutter switch temperature control Pr | Shop The World
From India
NewSerplex
Serplex® 24W Electric Foam Cutter with Switch & Temperature Controller 2mm Diamter Hot Pin Needle Cutter Foam Cutting Tool Electric Heating Pen Cutting Tool for KT Board, Foam & Polystyrene Craft
•APPLICATION: This foam cutter is versatile and suitable for various foam cutting tasks. Its ability to heat up quickly makes it convenient to use for tasks such as polystyrene foam cutting, carving, and even writing words on foam surfaces. This versatility makes it a valuable tool for crafters, artists, and professionals alike. [Note: Only suitable for low density styrofoam, such as pearl cotton, not sponge, the thickest foam can only be cut 9cm.]
•EASY TO USE: Step 1. Connect and switch on the power adapter. Step 2. Turn the switch on and wait for the temperature to rise to the usage temperature (about 10-30S). Step 3. Aim at the foam that needs to be cut, press down slowly, and move slowly along the line that needs to be cut. Step 4. After cutting, turn off the switch and wait for the foam cutter to cool down. [Recommended to rest for more than half an hour after 30 minutes of use, and should not work more than three hours a day.]
•ADVANTAGE: The foam cutter heats evenly preheat quickly, and can be heated to 210°C within 10 seconds. The non-slip rubber handle and the electric heating pen are lightweight, so your hands will not be tired after a long time of cutting work. The stainless steel heating thin tube is corrosion-resistant and high-temperature resistant and can adapt to a variety of heating environments. Equipped with a convenient temperature controller, this foam cutter lets you easily adjust the heat settings.
•ON/OFF SWTICH: Having on/off switch, very convenient to switch hot foam cutter on and off, so you don't have to keep unpluging it all the time! Carving fast, smooth and clean, without leaving debris. [Recommended continuous use hot wire foam cutter's time does not exceed 30 minutes, and the power can be turned off after cutting to extend the service life.]
•WARM TIPS: The foam cutting pen is connected to the adapter and then rotated at the interface to ensure that the product is energized, turns on the switch, wait for 30S after the cutting pen is sufficiently heated to cut. The heating tube can also be bent, but the pen can only be bent once. After bending, it cannot be straightened again, otherwise the heating core inside will be short-circuited; and it cannot be bent repeatedly at the same point, otherwise it may cause breakage.
