new Alphacool Eiskoffer Light - Bending Kit (29138)

More and more fans of water cooling rely on Alphacool's HardTubes for aesthetic and practical reasons. The great challenge for the user is that the tubing needs to bend to fit the water loop.To make this possible, the Alphacool Eiskoffer "Light" Kit contains most of the tools required to bend the HardTubes quickly and effectively. All you need is a hot air gun and a saw to cut the HardTubes to the desired length. This not only ensures a fantastic looking system, but also makes the assembly of the water cooling much easier.The Alphacool Eiskoffer Light Kit contains a large circular and a multi-sheet mandrel. This makes it easy to make any desired angles. All mandrels are designed for HardTubes with an outer diameter of 12, 13 or 16 mm. Two fitting stops are included so that the correct length can be measured immediately during bending. These simulate the depth of the Eiszapfen fittings. Four additional feeders with pin stops can be used in a variety of ways. Either as a support to create several radii simultaneously, or as an end stop point.All feeders and stops can be screwed onto any wooden board. The matching wood screws are included in the set. Two 80 cm long bending inserts for HardTubes with 10 and 13 mm inner diameter are available so that bending of the HardTubes is done correctly. The functions of all included tools are described in detail in the enclosed manual.The entire kit comes in a sturdy cardboard box. All tools are embedded in thick foam so that the tools are safely stowed away. Store the whole kit in it's desired place knowing every tool is organized and ready for your next project!With the Eiskoffer Light Kit you get a perfect start into your HardTube bending journey, ensuring professional looking bends straight out of the box.