myoware 20 wireless shield wirelessly transmit data esp32 w Pr | Shop The World
From USA
NewMyoWare
MyoWare 2.0 Wireless Shield - wirelessly Transmit Data with The ESP32-WROOM chip - Input 5V via USB C Connector - Output 3.3V - ESD Protection Diodes for USB Data Lines
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
•Espressif ESP32-WROOM wireless transmission: Take readings from MyoWare 2.0 Muscle Sensor; Note: Shield Only; Additional accessories are required
•MyoWare 2.0 Muscle Sensor Form Factor: 3x Female Snap Pins (Power and EMG Envelope Output): Easily connect to other MyoWare boards
•Note: MyoWare and the Wireless Shield are not intended for use in the diagnosis of disease or other conditions, or in the cure, mitigation treatment, or prevention of disease, in a man or other animals
•Built-in LiPo Battery: Rated Capacity: 40mAh; Nominal Voltage: 3.7V; MCP73831 Single Cell LiPo Charge IC: Charge Rate Set to 40mA; Input Voltage: 5V via USB Type C; Output Voltage: 3.3V via Qwiic Connector
•ESD Protection Diodes for USB Data Lines; Ideal Diodes for Protection on the VBATT and VUSB Nets; Resettable PTC Fuse (Rated 6V/500 mA); Switches: Power Source, Power ON/OFF; Board Dimensions: 63.5 mm x 38.000 mm (2.50 in. x 1.50 in
•Input Voltage: 5V via USB Type C Connector, Output Voltage (e.g. "VIN"): 3.3V via voltage regulator (RT9080), 3.3V via Qwiic Connector
From USA
