kuman Raspberry Pi 4 B Holder Breadboard Kit, 7 1 RAB Holder k | Shop The World
From USA
Newkuman
kuman Raspberry Pi 4 B Holder Breadboard Kit, 7 in 1 RAB Holder kit Compatible for Arduino, Mega 2560 & Raspberry Pi 3 Model B, 2 Model B,1 Model B+ RPI Zero and Zero W
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
•This 7 in 1 RAB Holder kit is designed by Kuman for the Raspberry Pi and for Arduino hobbyists, the holder is large enough for a Raspberry Pi 3B/ 2B/ 1B+/ Zero/ Zero W, for Arduino or Mega 2560, and a 400 hole or 830 hole Circuit Board breadboard(for Arduino rapsberrry pi motherboard and 400 breadboard are not included).
•Gift: GPIO 40 pin Table Card for wiring Pi and BCM codes for all RPI motherboard.
•Including RPi GPIO Breakout Expansion Board and Ribbon Cable, which are special for Raspberry Pi 3 Model B, 2 Model B, 1 Model B+ and zero/ zero W.
•This 830-tie/point breadboard includes an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails.
•Comes with male-to-male 65pcs jumper wires, red, green, and yellow LEDs (three for each color), ten 1kΩ resistors, a screwdriver, and some screws.
From USA
