g5v 2 dc12 12vdc dpdt 2 form c low signal pcb relay 2 pack g5 | Shop The World
From USA
NewKwaich
G5V-2-DC12 12VDC DPDT 2 Form C Low Signal PCB Relay 2 Pack, G5V-2 8-Pin Through-Hole DIL Miniature Sealed Relay, 0.6A 125VAC 0.6A 110VDC 2A 30VDC, 288Ω Coil, Non-Latching
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
•[MODEL & SPEC CHECK] 2-pack G5V-2-DC12 relay set for boards that require a 12VDC coil, DPDT / 2 Form C contact form, 8 through-hole PC pins, DIL terminal layout and matching G5V-2 bottom-view pin pattern. Confirm coil voltage, pin count, pin spacing and circuit load before ordering.
•[RATING & LOAD CHECK] Designed for low-signal control circuits using the G5V-2 12VDC standard coil. Contact rating references: 0.6A at 125VAC, 0.6A at 110VDC, 2A at 30VDC; use only within the rating required by your board and actual load conditions.
•[PCB FOOTPRINT CHECK] This is a miniature sealed PCB relay with solder PC-pin terminals, not a plug-in automotive blade relay. Match the existing relay marking, bottom-view terminal arrangement, mounting-hole footprint and board silkscreen before replacement.
•[CONTROL BOARD USE] Suitable for compatible signal/control PCB applications such as low-power equipment control, communication boards, security devices, test boards and repair projects that use the same G5V-2-DC12 relay footprint and specifications.
•[INSTALLATION NOTE] Disconnect power before service, desolder the existing relay carefully, clean the through-holes, avoid overheating the terminals and install in the correct orientation. Do not use if the existing relay has a different coil voltage, contact form or pin layout.
•[COMPATIBILITY NOTE] Model numbers and electrical specifications are used only to verify compatibility. This relay set is intended for compatible PCB designs using G5V-2-DC12 / G5V-2 12VDC layout; always confirm with the board manual, schematic or existing relay marking.
From USA
