fysetc flsn super racer pei build plate kit peo print bed fyse | Shop The World
From USA
NewFYSETC
FYSETC Flsn Super Racer PEI Build Plate Kit and PEO Print Bed
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
•1. A upgrade Replacement printing platform-Round JanusBPS 270mm/10.6inch, compatible with Flsn Super Racer model. This steel plate is Double-Side Coated, one side with Gold Powder, another with a Smooth PEI pre sticked, comes with a magnetic base.!!!Please re-measure your build plate before ordering, not rely on its printing size area.
•2. Flexible, removable, can stick very well. The flexible steel PEI sheet is made of high quality spring steel that won't kink or warp when you flex them slightly! High strength and heat resistance. Both sides can be used to print, just flip it over, more convenient. The pei sheet is pre-sticked by machine, no worry about the bubbles, please peel off the profective film on the pei surface before using.
•3. Double sides can be used and easy to install: simply stick the bottom sheet onto your heated bed, then place the steel platform on the top. When you auto-level and mesh auto level with Kliper software on your PEI sheet, if it's done on the textured side, it will create fluctuations with the auto-level system since it is textured. ONLY using auto-leveling on smooth side PEI, everything will work perfect.
•4. A NEW Round 270mm Print Bed Surface Top Plate Only: 1pc Diameter 270mm/10.6inch Smooth PEO+Textured PEI Flexible Removable Hot Bed Replacement Accessory, for 3D printer FLSN Super Racer (SR). A perfect spare part for the same size Magletic build plate kit (ASIN:B0B6J7XDKM) at our store. About 5mm larger than the build plate of Flsn QQ QQS PRO.
•5. Great First Layer Adhesion: **Do Not sand the PEO bed to avoid permanent damage.**This Double sided build plate is compatible with most 3d printer material, such as PLA, PETG, TPU, ABS, etc. No glue, No tap, An Appropriate Z axis is very important, if too low causing a filament buildup and scratch the print bed. Too high the prints come off the hotbed. Turn OFF the cooling fan and Slow down the speed to 10-25mm/s when going on the first layer. Adding Skirts and DRY filaments also help.
