ElecGear Hall Sensor Joystick Replacement Steam Deck, Electrom | Shop The World
From USA
NewElecGear
ElecGear Hall Sensor Joystick Replacement for Steam Deck, Electromagnetic No-Drifting Left and Right Thumbstick Unit Module PCB Assembly for MEDA and MHDA Controllers, Repair Tool Kit Included
ℹ
Products from the USA may come with an input voltage of 110V–120V, requiring a step-down transformer. Check the device wattage to select the correct power converter.
•[Hall Edition of Joystick for Steam Deck] – Electromagnetic edition of joystick replacement for Steam Deck. High sensitivity hall effect sensors inside. No wear on traditional carbon film resistor, say goodbye to drifting. The kit consists of left and right thumbstick modules for a direct replacement
•[What ElecGear did for a better Hall Stick] – 1. Works with both MEDA and MHDA controllers. 2. Hall sensor to eliminate the possible drifting in hardware level. 3. Pure analogical trim circuit with no latency. 4. ESD diode added to protect the unit from static electricity
•[Reminder of DIY] – 1. Safely power off your console. 2. Teardown your Steam Deck and take out the problem LR units. 3. Desolder the wire of sensitive cap off the PCB. 4. Solder the cap’s wire. 5. Install the new stick and connect the flex cable. 6. Calibrate the new module in desktop mode. (🔺Moderate soldering tools and skill needed for the replacing operation.)
•[What’s in Box] – 1. Replacement Joystick Modules (Hall Edition Left and Right). 2. PH0 Screwdriver. 3. Tweezers. 4. Plastic Opening Tools. (🔺Soldering tools and materials are NOT included)
From USA
